Zlide D24 Clearomizer - Innokin

Zlide D24 Clearomizer - Innokin

Meet the big brother of the Zlide D22: the Zlide D24!

And technically?

The Zlide D24 — 24 mm — shares the same characteristics as the Zlide 22 mm, with an increased tank capacity of 4 ml in its stainless steel body. Top-fill minimises the risk of leaks and ensures safety thanks to the top cap. You will also find a designer resin drip tip, an additional touch of elegance that you can swap according to your taste. The shape of this drip tip has the advantage of condensing the vapour and concentrating the flavours. This model focuses on flavour rendering, although it is also a strong performer in terms of vapour — now that is true versatility!

How to fill the Zlide D24?

Nothing could be simpler when it comes to filling the Zlide D24 clearomizer:

Unscrew the drip tip.
Slide the top cap, it will reveal the filling hole.
Fill the tank.
Put the components back in place.

Airflow: a cutting-edge system

Whatever your setting, the airflow system technology of the Zlide D24 will deliver pure flavours and a dreamy texture. We cannot hide it — Innokin has pulled out all the stops to offer you the very best that MTL vaping has to offer!

To adjust your draw as you wish, rotate the adjustment ring located at the base of the clearomizer.

The bonus: adjust your setting according to the coil used for maximum optimisation.

Which coils are compatible with the Zlide D24?

The Zlide D24 clearomizer is compatible with tried-and-tested coils: the Zenith coils!

Two coils are included in the kit:

The Zenith 1.2 ohm coil comes pre-installed in the clearomizer. To be used between 10 and 14W, it will give you concentrated flavours, dense vapour and a powerful tight draw. Back to basics for an MTL vape! Compatible with e-liquids containing nicotine salts. Preferably use e-liquids with a VG content of 50% or less.
The Zenith 0.8 ohm coil. To be used between 15 and 18W, it will allow you to vape thicker e-liquids for more vapour. Still in MTL!

How to change the coil?

Unscrew the Zlide D24 from its base.
Remove the coil to be changed by the threaded end.
Apply some e-liquid to the openings around the coil to prime it.
Insert the coil into the clearomizer by aligning the guides.
Screw the Zlide D24 back on and fill the tank.
Wait approximately 10 minutes for the e-liquid to properly saturate the coil before starting to vape, to avoid any risk of a dry hit.

Box contents

1 Zlide D24 clearomizer
1 Zenith 1.2 ohm coil
1 Zenith 0.8 ohm coil
1 set of replacement seals
1 replacement pyrex
1 user manual