J Series Coils - GeekVape

J Series Coils - GeekVape 

Pack of 5 replacement coils 

Coil selection and compatibility 

• 0.4 Ohm coils - 23 to 28W: Direct or semi-indirect inhalation, for a vapour-generous vape.

Ideal for low nicotine levels (from 0mg to 6mg/ml), they allow the use of e-liquids from 50/50 to 30/70 PG/VG.

• 0.6 ohm coils - 16 to 21W: Indirect inhalation, for a good balance between flavour and vapour.

Designed for all nicotine levels (and nicotine salt). Prefer 50/50 PG/VG compositions.

• 0.8 ohm coils - 12 to 17W: Indirect inhalation, for a flavour-rich vape.

Perfect for high nicotine levels and salts. A 50/50 PG/VG ratio or a more fluid ratio such as 70/30 is recommended.

• 1.2 ohm coils - 8 to 12W: Very indirect inhalation, focused on flavour and a tight draw.

The best choice for your nicotine salts, they work very well with a 50/50 and 70/30 PG/VG composition. 

The J Series coils are compatible with the GeekVape J Series empty cartridge designed for the Digi Max and Digi Pro kits. 

When to change your coil? 

We recommend a minimum change every 15 days to 3 weeks to avoid e-liquid leaks in your equipment. 

However, depending on your vaping frequency, the composition of your e-liquid or the presence of dust in your e-cigarette, your coil may degrade faster. 

In any case, make sure to change your coil: 

• If it leaks after 10 days of use

• If the flavour of your e-liquid seems altered

• If you experience a burnt or ashy taste

How to install a new coil? 

• Remove the old coil and dispose of it for recycling

• Saturate the cotton of your new coil with your e-liquid

• Insert your new coil into your previously cleaned and dried clearomizer/cartridge

• Fill with e-liquid and wait approximately 10 minutes to avoid damaging your coil

Contents of the GeekVape J Series coils box 

• 5 J Series coils