⚠️ The most common error messages

Your e-cigarette displays messages and you did not take English at school? 😵‍💫 Don’t worry, we’ll help you understand them more clearly 🙏

• Your e-cigarette displays: “Check coil” or "No coil detected"

These messages on your e-cigarette indicate a connection problem between your Mod and the clearomiser. Put simply, your e-cigarette is telling you that it cannot detect the atomiser. Depending on the brand or model of your e-cigarette, the error message may vary: "No atomizer", "No atomiser found", "Check atomizer". If you use an e-cigarette without a screen, the LED indicator on your atomiser will flash to signal the technical issue.

To resolve this issue, it is important to check the assembly and cleanliness of the various components. First of all, the connection fault may simply be due to the atomiser thread not being tightened properly, preventing the electrical current from flowing. To check this, switch off your e-cigarette, unscrew the atomiser and carefully clean the thread and contact pin if there are any traces of dirt. Then screw everything back together and switch your vape device back on.

If the error message persists, check that the issue is not caused by the coil being incorrectly screwed in or clogged, which can happen after several refills. Repeat the same procedure for the coil: unscrew it, clean it with a dry cloth and screw it back in. If the error message continues to appear, it is probably time to replace your coil.

By following these steps, you should be able to resolve the "No coil detected" issue on your e-cigarette. If the message persists despite all these checks, it may be helpful to consult a professional or contact your e-cigarette manufacturer for further assistance.

• Your e-cigarette displays "Atomizer low" and "Atomizer short"

These messages may indicate two separate issues. They may appear on your screen if the resistance value of the coil you are using is too low. For example, not all e-cigarettes support Sub-Ohm vaping, which requires a coil with a value below 1 Ohm. It is therefore essential to check that the coils you buy are compatible with the operating ranges of your atomiser and battery. If you encounter this issue, simply choose a coil with a higher resistance value (Ohm), and the error message should disappear.

In addition, your e-cigarette may not detect the coil. The atomiser may be screwed on too tightly, creating poor contact. In this case, slightly unscrew your atomiser and the connection should be restored. Also make sure to clean the connection pins if necessary, as they may also be causing this issue. If the problem persists, try unscrewing and screwing your coil back in, or replace it if nothing works.

• Your e-cigarette displays "Check battery”:

This may be due to ageing or a fall. This alert generally indicates that an electronic fault has been detected in the box mod, often caused by a loose soldered wire. In this situation, it is recommended that you send your box mod to the after-sales service rather than attempting to repair it yourself, as this can be delicate and requires a certain level of expertise.